High performance 4 channel car amplifier CLUBA754
Features Compact size High and low level input Variable crossover Low noise and distortion Input Level Control Full on-board protection Preamp Outputs Class H amp technology Turn-on mode
- Tồn kho :
- Hàng luôn có sẵn
Value engineered car amplifier with JBL power and performance.
The Club A754 4-channel amplifier delivers a powerful 75-Watts RMS to each of the front
and rear speakers in your car. You can also bridge the amp to 2-channel mode to drive
a couple subs with 200 watts RMS or 3-channel mode to drive both a pair of full range
speakers and a subwoofer. Speaker-level inputs allow this amplifier to integrate into almost
any system, even one using your car’s factory radio. Separate high-pass and low-pass
crossovers on the front and rear channels allow you dial in the perfect roll off to best suit
speaker placement and cabin acoustics
Features and Benefits
The JBL Club A754 amplifier features a low-profile chassis and a small overall footprint to fit in
more vehicles where available space is limited.
High and low level input
Speaker-level and low-level inputs allow the Club A754 to integrate with both aftermarket and
factory car stereo systems.
Unlike many amplifiers available at similar prices, the JBL Club A754 features variable
electronic crossovers for precise system tuning and performance.
Low noise and distortion
The Club A754 has been engineered using Balanced Differential Inputs to ensure low noise
and distortion even at high output levels. This also makes it far less susceptible to line induced
Input Level Control
When low-level inputs are used, this control adjusts the input sensitivity between 200mVrms
and 2.0 Vrms. When high-level inputs are used, this control adjusts the input sensitivity
between 2Vrms and 20Vrms.
Full on-board protection
On-board circuitry protects the Club A754 from shorts, high-temperature, overvoltage and
undervoltage. An LED indicator is provided to let you know when one of these conditions exists.
Using multiple amplifiers, the Club A754 has full range preamp outputs allowing you to feed an
additional amplifier without using splitters.
Class H amp technology
The JBL Club A754 4 channels subwoofer amplifier delivers 400-Watts RMS using a Class H
amplifier design to ensure high output and minimum current draw.
This switch changes DC to REM to adapt with low-level signals or high-level signals, this is especially
helpful as part of remote turn-on lead of your installation more choice. A selectable “Turn-on mode”
can protect battery to avoid current drain, when you don’t expect to turn on your amplifier.
Đánh giá sản phẩm
What’s in the box:
One Club A754 four channel amplifier
4 Bare wire-to-RCA adapters
Four 30A ATO fuses (2 installed, 2 spare)
Two JBL stickers
4 Mounting screws (M4 x 53mm)
1 logo badage
4 channel car amplifier
75 watts RMS x 4 at 4 ohms
(100 watts RMS x 4 at 2 ohms)
200 watts RMS x 2 at 4 ohms in bridged
mode (4-ohm stable in bridged mode)
Variable high- and low-pass filters
(32–320Hz, 12dB/octave) on front and
Preamp and speaker-level inputs
Fuse rating: 30A x 2
8-gauge power and ground leads
recommended – wiring and hardware not
included with amplifier
W x H x D = 320mm x 51.3mm x 180mm
W x H x D = 12-5/8" x 2-1/16" x 7-1/8"